Cheetah Pregius Camera with 10 GigE Vision Interface – User Manual
October 8, 2020
Page
105
of
170
Rev 1.0
GevCurrentIPConfigurationDHCP
Indicates whether a DHCP IP configuration scheme is
activated on the network interface.
GevCurrentIPConfigurationPersistentIP
Indicates whether a Persistent IP configuration scheme
is activated on the network interface. A persistent IP
address is hard-coded in non-volatile memory.
GevCurrentIPAddress
Displays the host computer’s network IP Address.
GevCurrentSubnetMask
Displays the subnet mask of the interface.
GevCurrentDefaultGateway
Displays the default gateway IP address to be used on the
network interface.
GevPersistentIPAddress
Indicates the Persistent IP address for the network interface.
The persistent IP address is re-used by the camera on power-up
when Persistent IP is enabled.
GevPersistentSubnetMask
Indicates the Persistent subnet mask associated with the
Persistent IP address on the network interface.
GevPersistentDefaultGateway
Indicates the Persistent default gateway for the network
interface.
GevLinkSpeed
Indicates the speed of transmission negotiated by network interface in
Mbps.
GevCCP
Enables granting privilege to an application. Options are open access,
exclusive access, or control access.
GevPrimary Application Socket
Indicates the UDP source port of the primary application.
GevPrimary Application IP Address
Indicates the address of the primary application.
GevMCPHostPort
Controls the port to which the device must send messages. Setting this
value to 0 closes the message channel.
GevMCDA
Controls the destination IP address for the message channel.
GevMCTT
Provides the message channel transmission timeout value in
milliseconds.
GevMCRC
Controls the number of retransmissions allowed when a message
channel message times out.
GevMCSP
Indicates the source port for the message channel.
GevSCCFG UnconditionalStreaming
Enables the camera to continue to stream for this stream
channel if its control channel is closed or regardless of the
reception of any ICMP messages (such as destination
unreachable messages).
GevSCPHostPort
Indicates the port to which the device must send data stream.
GevSCPSFireTestPacket
When this bit is set, the device will fire one test packet.
GevSCPSDoNotFragment
This bit is copied into the "do not fragment" bit of IP header of
each stream packet.
GevSCPD
Indicates the delay (in timestamp counter unit) to insert between each
packet for this stream channel.
GevSCDA
Indicates the destination IP address for this stream channel.
