MSD-804FD
User’s Guide
230
Problem
Cause/Check item/Solution
Page
“RETRY OVER
ERROR” is displayed
and control command
is not sent completely.
Is the registered reply command correct?
Make sure that the setting of
“TIME OUT” for checking control
commands is not too short.
Control through CEC
cannot be performed.
Do you use cables supporting CEC?
For CEC control, an HDMI cable supporting CEC is required.
Does the display device support CEC? Is the HDMI association
function of the display device set correctly?
Enable the HDMI link control and Power on association function (for
turning on the display device by external devices) of the display
device.
Others
Input signals
temporarily
disappear when input
channel is switched.
When the CEC connection changes, EDID may change. In this case,
input signals are interrupted. Check the connection settings.
Devices cannot be
controlled through
CEC.
Are HDMI cables supporting CEC being used?
To use CEC, enable HDMI link control of the connected devices
(such as LCD TVs, Blu-ray recorder, and so on).
