2-29
2
2.12 4899A RACK MOUNTING INSTRUCTIONS
The Model 4899A is held in its rack mounting kit with a winged-'U' shaped
bracket. Perform the following steps to install a 4899A in a rack mount-
ing kit:
1.
Hold the 4899A at a 30 degree nose down angle and place the front
bezel through the rack mount kit from the rear of the kit. Push it
forward through the opening until the rubber feet line up with the
holes in the rack mounting kit. Push the unit down until it rests
flat on the kit and the feet are in the four holes.
2.
Repeat step 1 for a second unit if two units are being held in one
rack mounting kit.
3.
A line the unit(s) so the bezels are parallel with the front of the rack
mount kit and protrude equally through the front panel of the rack
mounting kit.
4.
Set the bracket so its two holes line up with the holes in the rack
mounting kit extrusion. Use the supplied 4-40 screws to hold the
bracket to the extrusion. Do not overtighten.
5.
Use the supplied 10-32 screws to bolt the rack mounting kit into
the rack.
Summary of Contents for 4809A
