ICS ELECTRONICS 4809A, Instruction Manual, Page: 123 / 131

A-24
A3
4. Install the Connector/Switch Assembly from the inside. Use the metric
studs and two thin lock washers to hold the assembly to the panel
as shown in Figure A-9.
5. Route the flat ribbon cable to the board so it avoids any high
RFI or electrical noise area. Plug the cable into J2.
6. Mark or silkscreen the switch functions onto the rear panel
as shown in Figure A-10. Identify the 5 address rockers as
shown and switch 6 for your application.
BUS ADDRESS
1 8 4 2 1 0 - -
6
0.060 typ.
Space letters
on rockers,
0.1 centers typ.
Figure A-10 Switch Silkscreen Detail
Figure A-11 IEEE-488.1 Figure 21