ICS ELECTRONICS 4809A, Instruction Manual

Page: 122 / 131

A-23
A3
Figure A-9 GPIB Connector/Switch Board Assemblies
(a) Horizontal/Connector Assembly
(b) Vertical Connector/Switch Assembly
2. Locate a blank area on the host chassis rear panel as shown in
Figure A-11. Leave enough room inside for the flat ribbon cable
bend radius.
3. Machine the cutouts shown in Figure A-12. If the rear panel is
thicker than 0.050 inches, mill a 2.3 in x 0.8 in relief on the inside
of the panel for the Amphenol 57-20240 connector.
1.35
3.50
0.82
0.50
L
3.00
0.50
0.82
1.65
L