![background image](http://html2.mh-extra.com/html/icom/ic-7800/ic-7800_instruction-manual_4148585082.webp)
4-34
■
Data mode (AFSK) operation
When operating AMTOR or PACKET with your TNC
and/or PC software, consult the manual that comes
with the TNC and/or the software.
q
Connect a PC and TNC to the transceiver. (p. 2-8)
w
Push a band key to select the desired band.
e
Push [SSB] or [AM/FM] to select the desired oper-
ating mode.
r
Push [DATA] to turn data mode ON.
• One of “-D1,” “-D2” or “-D3” is additionally appears.
• During data mode selection, pushing [DATA] for 1 sec.
to select data mode 1 (D1), 2 (D2) and 3 (D3) in se-
quence.
t
Rotate the main dial to tune into the desired signal
and decoded correctly.
• Also use the tuning indicator of the TNC or software.
• During SSB data mode,
1
⁄
4
tuning function can be used
for critical tuning.
y
Operate the PC (software) or TNC to transmit.
• When operating in SSB data mode, adjust the TNC out-
put level so that the ALC meter reading doesn’t go out-
side the ALC zone.
NOTE:
When SSB data mode is selected, the audio
input from the [ACC1] (pin 6) is used for transmis-
sion instead of [MIC]’s.
The fixed condition is used for SSB data transmis-
sion as follows:
• [COMP]
: OFF
• Tx bandwidth
: MID
• Tx Tone (Bass)
: 0
• Tx Tone (Trebles) : 0
✔
For your information
Carrier frequency is displayed when SSB data mode
is selected.
See the diagram left for the tone-pair example.
200 Hz
2125 Hz
2325 Hz
Carrier frequency
(displayed frequency)
Appears
[AM/FM]
[SSB]
[AF]
[DATA] Main dial
Band keys
4
RECEIVE AND TRANSMIT