D
D
Convenient functions for transmit
D
D
About 5 MHz band operation (USA version only)
Operation on the 5 MHz band is allowed on 5 discrete
frequencies and must adhere to the following:
• USB mode
• Maximum of 50 watts ERP
(Effective Radiated Power)
• 2.8 kHz bandwidth
It’s your responsibility to set all controls so that trans-
mission in this band meets the stringent conditions
under which we may use these frequencies.
NOTE:
We recommend that you store these fre-
quencies, mode and filter settings into memory
channels for easy recall.
*The FCC specifies center frequencies on the
5 MHz band. However, the IC-7800 displays carri-
er frequency. Therefore, tune the transceiver to
1.5 kHz below the specified FCC channel center
frequency.
• Speech compressor
(p. 6-5)
➥
Push [COMP] to turn the speech compressor ON
and OFF.
• Pushing [COMP] for 1 sec. to select the compression
bandwidth from wide, middle and narrow.
• VOX (voice operated transmit)
(p. 6-2)
➥
Push [VOX/BK-IN] to turn the VOX function ON
and OFF.
• “VOX” appears when the VOX function is ON.
• Transmit quality monitor
(p. 6-4)
➥
Push [MONI] to turn the monitor function ON and
OFF.
• Rotate [MONI GAIN] to adjust the monitor gain.
• Monitor indicator (above [MONI] switch) lights when
the monitor function is ON.
• Audio tone control
(p. 12-4)
➥
Push [F-7•SET] then [F-1•LEVEL] to enter level
set mode. Select an item with [F-1•
Y
]/[F-2•
Z
]
then rotate the main dial to adjust the audio tone.
4-3
4
RECEIVE AND TRANSMIT
IC-7800 Tuning
FCC Channel
Frequency*
Center Frequency*
5.33050 MHz
5.33200 MHz
5.34650 MHz
5.34800 MHz
5.36650 MHz
5.36800 MHz
5.37150 MHz
5.37300 MHz
5.40350 MHz
5.40500 MHz
To assist you in operating the 5 MHz band within the
rules specified by the FCC, transmission is illegal on
any 5 MHz band frequency other than the 5 fre-
quencies indicated in the table above.
