IBM System Storage DS3000, Programming Manual

Page: 346 / 652

Parameter
Parameter Description
iscsi-host-port The identifier of the port on the storage subsystem on
which you want to refresh the DHCP parameters. Enclose
the iSCSI host port name in square brackets ([ ]).
Notes
This operation ends the iSCSI connections for the portal and brings down the portal temporarily.
Start Array defragment
This command starts a defragment operation on the specified Array.
NOTE Defragmenting a Array starts a long-running operation that you cannot stop.
Syntax
start volumeGroup [volumeGroupName] defragment
Parameter
Parameter Description
volumeGroup
The alphanumeric identifier of the Array (including - and
_) that you want to defragment. Enclose the volume
group identifier in square brackets ([ ]).
Notes
Host I/O errors might result in the Arrays with more than 32 volumes. This operation also might result
in internal controller reboots because the timeout period ends before the Array definition is set. If you
experience this issue, quiesce the host I/O operations, and try the command again.
Minimum Firmware Level
6.10
Start Array export
This command moves a Array into an Exported state. Then you can remove the drives that comprise the
Array and reinstall the drives in a different storage subsystem.
NOTE Within the Array, you cannot move volumes that are associated with the premium features from
one storage subsystem to another storage subsystem.
Syntax
start volumeGroup [volumeGroupName] export
3-300
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide