IBM System Storage DS3000, Programming Manual

Page: 355 / 652

Stop Controller Diagnostic
This command stops the controller diagnostic tests that were started by the
start controllerdiagnostic
command.
Syntax
stop controller [(a | b)] diagnostic
Parameters
Parameter Description
controller
The setting to return information about a specific controller
in the storage subsystem. Valid controller identifiers are
a or
b
, where
a
is the controller in slot A, and
b
is the controller
in slot B. Enclose the controller identifier in square brackets
([ ]). If you do not specify a controller, the storage
management software returns a syntax error.
Stop Disk Pool Locate
This command turns off the indicator lights on the drives that were turned on by the start diskPool
locate command.
Syntax
stop diskPool locate
Parameters
None.
Stop Drive Channel Fault Isolation Diagnostics
This command stops the drive channel fault isolation diagnostics, which stops the
start drive channel
fault isolation diagnostics
command before it completes.
See the “Start Drive Channel Fault Isolation Diagnostics” on page 3-292 command for more information.
Syntax
stop driveChannel faultDiagnostics
Parameters
None.
Notes
Use the
start driveChannel faultDiagnostics
command and the
save driveChannel faultDiagnostics
command with the
stop driveChannel faultDiagnostics
command. These commands are needed to start
the diagnostic test and save diagnostic test results to a file.
You can also stop the
start driveChannel faultDiagnostics
command at any time by pressing
Ctrl+C
.
Chapter 3. Script Commands
3-309