IBM System Storage DS3000, Programming Manual

Page: 206 / 652

Parameter Description
remoteStorageArrayNameWwid The World Wide Identifier (WWID) of the storage
subsystem for which you are resetting the iSCSI IP
address. You can use the WWID instead of the storage
subsystem name to identify the storage subsystem.
Enclose the WWID in angle brackets (< >).
Minimum Firmware Level
7.84
Reset Storage Subsystem Battery Install Date
This command resets the age of the batteries in a storage subsystem to zero days. You can reset the
batteries for an entire storage subsystem or just the battery for a specific controller or in a specific battery
pack.
Syntax
reset storageSubsystem batteryInstallDate [controller=(a | b)
| batteryPack=(left | right)]
Parameter
Parameter Description
controller
The controller that contains the battery for which you want
to reset the age. Valid controller identifiers are
a
or
b
, where
a is the controller in slot A, and b is the controller in slot B.
batteryPack The battery pack contains both a left battery and a right
battery. Valid identifiers are
left
or
right
, where
left
is the
battery that supports the controller in slot A, and right is
the battery that supports the controller in slot B. Use the
batteryPack
parameter only for controllers with battery
packs. The controller and batterypack parameters are mutual
exclusive. You can specify either parameter but not both at
the same time.
Note: The DS3000 does not have battery packs.
Notes
A controller might have a battery associated with it, so the controller is identified as either a or b. With
the release of the DS5100, DS5300 controller enclosure, battery packs inside the interconnect-battery
CRU/FRU are identified as either left or right. If the command statement uses the wrong parameter, an
error appears.
3-160
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide