IBM System Storage DS3000, Programming Manual

Page: 240 / 652

v
The IPv6HopLimit option is 64.
v
The IPv6NdReachableTime option is 30000 milliseconds.
v
The IPv6NdRetransmitTime option is 1000 milliseconds.
v
The IPv6NdTimeOut option is 30000 milliseconds.
v
The tcpListeningPort option is 3260.
Set Controller Service Action Allowed Indicator
This command turns off or on the Service Action Allowed indicator light of a controller in a controller
module. If the storage subsystem does not support the Service Action Allowed indicator light feature, this
command returns an error. If the storage subsystem supports the command but is unable to turn on or
turn off the indicator light, this command returns an error. (To turn on or turn off the Service Action
Allowed indicator light on the power-fan CRU or the interconnect-battery CRU, use the
set enclosure
serviceAllowedIndicator
command.)
Syntax
set controller=[(a | b)] serviceAllowedIndicator=(on | off
Parameters
Parameter Description
controller
The controller that has the Service Action
Allowed indicator light that you want to turn
on or turn off. Valid controller identifiers are
a
or b , where a is the controller in slot A, and b
is the controller in slot B. Enclose the controller
identifier in square brackets ([ ]). If you do not
specify a controller, the controller firmware
returns a syntax error.
serviceAllowedIndicator
The setting to turn on or turn off the Service
Action Allowed indicator light. To turn on the
Service Action Allowed indicator light, set this
parameter to
on
. To turn off the Service Action
Allowed indicator light, set this parameter to
off .
Notes
This command was originally defined for use with the DS4800 (models 82, 84, and 88) controller module.
This command is not supported by controller modules that were shipped before the introduction of the
DS4800 (models 82, 84, and 88) controller module. The DS3500 series, DS3950, DS4200, DS4700, DS5020,
DS5100, and DS5300 controllers also support this command.
Set Disk Pool
This command sets the attributes associated with a disk pool based on the specified parameters.
Syntax
set diskPool (diskPool=[
diskPoolName] | diskPools=[diskPoolName1... diskPoolNamen] | allDiskPools)
[reserveDriveCount=reserveDriveCountValue |
warningThreshold=(warningThresholdValue | default) |
criticalThreshold=(criticalThresholdValue | default) |
3-194
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide