IBM System Storage DS3000, Programming Manual

Page: 288 / 652

The
set storageSubsystem isnsServerRefresh
command returns an error if you did not set the
configuration method to DHCP. To set the configuration method to DHCP, use the
set storageSubsystem
isnsIPV4ConfigurationMethod
command.
Set Storage Subsystem Learn Cycle
This command sets the learn cycle for the battery backup unit, which enables the storage management
software to predict the remaining battery life. Learn cycles run at set intervals, and they store the results
for software analysis.
Syntax
set storageSubsystem learnCycleDate
(daysToNextLearnCycle=
numberOfDays |
day= dayOfTheWeek ) time= HH:MM
Parameters
Parameter Description
daysToNextLearnCycle
Valid values are
0
through
7
, where 0 is immediately and 7 is in seven days.
The
daysToNextLearnCycle
parameter takes place up to seven days after the
next scheduled learn cycle.
day
Valid values for the day parameter include the days of the week (
Sunday
,
Monday , Tuesday , Wednesday , Thursday , Friday , and Saturday ). Setting the day
causes the next learn cycle to be scheduled on the specified day, after the
currently scheduled learn cycle.
time The time in 24-hour format; for example 8:00 a.m. is entered as 08:00 . Nine
o’clock p.m. is entered as
21:00
, and 9:30 p.m. is entered as
21:30
.
Notes
You can set the learn cycle to occur only once during a seven-day period.
The time parameter selects a specific time that you want to run the learn cycle. If a value is not entered,
the command uses a default value of 00:00 (midnight).
If the day and time specified are in the past, the next learn cycle takes place on the next possible day
specified.
Set Storage Subsystem Redundancy Mode
This command sets the redundancy mode of the storage subsystem to either simplex or duplex.
Syntax
set storageSubsystem redundancyMode=(simplex | duplex)
Parameter
Parameter Description
redundancyMode
Use
simplex
mode when you have a single controller. Use
duplex mode when you have two controllers.
3-242
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide