IBM System Storage DS3000, Programming Manual

Page: 326 / 652

Minimum Firmware Level
5.40
Show String
This command shows a string of text from a script file. This command is similar to the echo command in
MS-DOS and UNIX.
Syntax
show “ string ”
Parameters
None.
Notes
Enclose the string in double quotation marks (“ ”).
Show Thin Logical Drive
This command returns the expansion history or the consumed capacity for the specified thin logical drive
or logical drives.
Syntax
show (allLogicalDrives | logicaldrive [logicaldriveName] |
logicaldrives [logicaldriveName1 ... logicaldriveNameN])
(consumedCapacity | (expansionHistory [file=fileName]))
Parameters
Parameter Description
allLogicalDrives
The setting to return information about all of the logical
drives in the storage subsystem.
logicaldrive or logicaldrives The name of the specific logical drive for which you are
retrieving information. You can enter more than one
logical drive name. Enclose the logical drive name in
square brackets ([ ]). If the logical drive name has special
characters, you also must enclose the logical drive name
in double quotation marks (" ").
consumedCapacity
The setting to return a concise list of information about
the consumed capacity of the thin logical drives.
expansionHistory
The setting to return a concise list of information about
the expansion history of the thin logical drives.
file
The
file
parameter specifies a file to log the output of
the
expansionHistory
parameter. The file is valid only
when used with the expansionHistory parameter. An
invalid file name causes the command to fail.
Notes
With the
expansionHistory
parameter, the command returns information similar to the example shown
below:
3-280
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide