IBM System Storage DS3000, Programming Manual

Page: 151 / 652

You can have a storage subsystem configuration with more than one set of encrypted subsystems or disk
pools. Each subsystem or disk pool can have a unique security key. The character string generated by the
keyIdentifier
parameter is a string that you can read and that enables you to identify the security key
that you need. You can create a
keyIdentifer
by using one of these methods:
You can enter up to 189 alphanumeric characters for a key identifier. The key identifier cannot have these
characters:
v
White spaces
v Punctuation
v
Symbols
If you do not enter the
keyIdentifer
parameter, the controller automatically generates the
keyIdentifer
parameter.
Additional characters are automatically generated and appended to the end of the string that you enter
for the key identifier. If you do not enter any string for the
keyIdentifier
parameter, the key identifier
consists of only the characters that are automatically generated.
Your pass phrase must meet these criteria:
v
The pass phrase must be between eight and 32 characters long.
v The pass phrase must contain at least one uppercase letter.
v
The pass phrase must contain at least one lowercase letter.
v
The pass phrase must contain at least one number.
v
The pass phrase must contain at least one non-alphanumeric character, for example, < > @ +.
Note: If your pass phrase does not meet these criteria, you will receive an error message and will be
asked to retry the command.
Create Enhanced Remote Mirroring
This command creates both the primary logical drive and the secondary logical drive for a Synchronous
Remote Mirrored pair. This command also sets the write mode (Metro Mirror or Global Copy) and the
synchronization priority.
Syntax
Note: In previous versions of this command the feature identifier was
remoteMirror
. This feature
identifier is no longer valid and is replaced by
syncMirror
.
create syncMirror primary="primarylogicalDriveName"
,
n
secondary="secondarylogicalDriveName"
,
n
(remoteStoragesubsystemName="storagesubsystemName" |
,
n
remoteStoragesubsystemWwn="wwID")
,
n
[remotePassword="password"
,
n
syncPriority=(highest | high | medium | low | lowest)
,
n
autoResync=(enabled | disabled)
,
n
writeOrder=(preserved | notPreserved)
,
n
writeMode=(synchronous | asynchronous)]
Parameters
None
Chapter 3. Script Commands
3-105