IBM System Storage DS3000, Programming Manual

Page: 200 / 652

Parameters
Parameter Description
localVolume or localVolumes The name of the primary volume (the volume on the
local storage subsystem) that you want to remove. You
can enter more than one volume name. Enclose the
volume name in square brackets ([ ]). If the volume
name has special characters, you also must enclose the
volume name in double quotation marks (" ").
Minimum Firmware Level
6.10
Remove VolumeCopy
This command removes a VolumeCopy pair.
Syntax
remove VolumeCopy target [
targetName] [source [sourceName]
copyType=(online | offline)]
Parameters
Parameter Description
target
The name of the target logical drive that you want to
remove. Enclose the target logical drive name in square
brackets ([ ]). If the target logical drive name has special
characters, you also must enclose the target logical drive
name in double quotation marks (“ ”).
source
The name of the source logical drive that you want to
remove. Enclose the source logical drive name in square
brackets ([ ]). If the source logical drive name has special
characters, you also must enclose the source logical drive
name in double quotation marks (“ ”).
copyType
Use this parameter to identify that a VolumeCopy has a
FlashCopy . If the VolumeCopy has a FlashCopy , set this
parameter to online. If the VolumeCopy does not have a
FlashCopy, set this parameter to offline.
Rename Enhanced FlashCopy Logical Drive
This command renames an existing Enhanced FlashCopy logical drive.
Syntax
set enhancedFlashCopyLogicalDrive ["enhancedFlashCopyLogicalDriveName"]
userLabel="enhancedFlashCopyImageLogicalDriveName
3-154
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide