IBM SAN768B-2, Installation, Service And User Manual

Page: 99 / 186

2. Remove the cables from the cable management comb and rearrange the cables
around the comb.
3.
Unscrew and save the four screws holding the comb to the chassis (see
Figure 24). Support the comb to prevent it from falling.
4. Remove the cable management comb.
Installing a cable management comb
Complete the following steps to install a cable management comb.
1. Align the comb with the four screw holes on the chassis.
2.
Position, insert, and tighten the four screws to secure the cable management
comb to the chassis.
3. Arrange the cables along the cable management comb.
4. Replace the chassis door.
Removing and installing port and application blades
This section describes how to remove and install port and application blades.
Attention: A filler panel should be removed only when being replaced with
another blade or a filler panel. Any slot that is not occupied by a blade should be
occupied by a filler panel to ensure correct cooling of the chassis and protection
from dust.
b768ig067
Figure 24. Cable management comb
Chapter 5. Removing and installing components
69