7.
Disconnect all cables and transceivers from the blade. For mSFP transceivers
(FC8-64 only), it is recommended that you use the pull tab to remove the
transceiver from the blade before removing the cable from the transceiver.
8.
Unscrew the two thumbscrews from the top and bottom ejectors on the blade
(see Figure 25) using the Phillips screwdriver. Unscrew the top thumbscrew
until it pops out. This initiates a hot-swap request.
9.
Wait for the power LED to turn off in response to the hot-swap request before
removing the blade.
10.
Open the ejectors by pulling them toward the center of the blade face. Pull the
blade out of the chassis using the ejectors (Figure 25).
11.
If the blade is not being replaced by another blade, install a filler panel. See
“Removing and installing blade filler panels” on page 72.
Installing a blade
Complete the following steps to install a port or application blade.
Attention:
Follow ESD precautions (see “ESD precautions” on page xix).
1.
Orient the blade so that the ports are at the front of the chassis and the flat side
of the blade is on the left.
b768ig068
Figure 25. Port and application removal and installation (FC16-48 port blade shown as
example)
Chapter 5. Removing and installing components
71
Summary of Contents for SAN768B-2
