IBM SAN768B-2, Installation, Service And User Manual

Page: 114 / 186

Time and items required
The installation procedure for the core switch blade takes approximately 30
minutes. The following items are required for the core switch blade installation:
v
ESD grounding strap
v Phillips #2 screwdriver
v
Replacement core switch blade (CR16-8).
Verifying the necessity of installation
Confirm that you need to replace the core switch blade before continuing. The
following events might indicate that a core switch blade is faulty:
v
The status LED on the core switch blade is lit amber, or the power LED is not
lit.
v The slotShow command does not show that the core switch blade is enabled.
v
The haShow command indicates an error.
v Any of the following messages display in the error log:
– “Slot unknown” message relating to a core switch blade slot
– core switch blade errors or I
2
C timeouts
– FRU: FRU_FAULTY messages for a core switch blade
– Configuration loader messages or “Sys PCI config” messages
– Generic system driver messages (“FABSYS”)
– Platform system driver messages (“Platform”)
– Error messages that indicate a problem with a core switch blade
– Function fail messages for the core switch blade master
For more information about error messages, refer to the Fabric OS Message
Reference .
Removing a core switch blade (CR16-8)
The SAN768B-2 continues to operate while a core switch blade is being replaced.
Attention: Follow ESD precautions (“ESD precautions” on page xix).
Note: The CR16-8 blade is compatible only with the SAN768B-2
Complete the following steps to remove a CR blade.
1.
Remove the chassis door (see “Removing and installing the chassis door” on
page 67).
2. Unscrew the two thumb screws from the ejectors on the blade using the
Phillips screwdriver. Unscrew the top thumb screw until it pops out. This
initiates a hot-swap request.
3. Label and then disconnect cables from the faulty core switch blade.
4. Open the ejectors by rotating them toward the center of the blade face. Pull the
blade out of the chassis using the ejectors. (see Figure 28 on page 85).
84
SAN768B-2 Installation, Service, and User Guide