IBM SAN768B-2, Installation, Service And User Manual

Page: 65 / 186

2. Set up the SAN768B-2 IP address by entering the ipaddrset -chassis command
at the prompt.
swDir:admin> ipaddrset -chassis
Enter the information at the prompts. Specify the -chassis IP address. The -sw 0
IP address is not valid on this chassis.
Note: The addresses 10.0.0.0 through 10.0.0.255 are reserved and used
internally by the SAN768B-2. External IPs must not use these addresses.
3. Set up the CP0 blade IP address by entering the ipaddrset -cp 0 command at
the prompt.
swDir:admin> ipAddrSet -cp 0
Enter the requested information at the prompts.
4. Set up the CP1 blade IP address by entering the ipaddrset -cp 1 command at
the prompt.
swDir:admin> ipAddrSet -cp 1
Enter the requested information at the prompts.
The following is a sample IP configuration for the SAN768B-2 (chassis) and the
two CP blades (cp0 and cp1).
swDir:admin> ipaddrset -chassis
Ethernet IP Address [0.0.0.0]: 123.123.123.120
Ethernet Subnetmask [0.0.0.0]: 123.123.123.123
Fibre Channel IP Address [0.0.0.0]:
Fibre Channel Subnetmask [0.0.0.0]:
Issuing gratuitous ARP...Done.
Committing configuration...Done.
swDir:admin> ipaddrset -cp 0
Host Name [cp0]:
Ethernet IP Address [10.77.77.75]:
123.123.123.121
Ethernet Subnetmask [0.0.0.0]: 123.123.123.123
Gateway IP Address [0.0.0.0]: 123.123.123.124
IP address is being changed...Done.
Committing configuration...Done.
swDir:admin> ipaddrset -cp 1
Host Name [cp1]:
Ethernet IP Address [10.77.77.74]:
123.123.123.122
Ethernet Subnetmask [0.0.0.0]: 123.123.123.123
Gateway IP Address [0.0.0.0]: 123.123.123.124
IP address of remote CP is being changed...Done.
Committing configuration...Done.
swDir:admin>
reboot
Logging off the serial console port and disconnecting the serial cable
You can use the serial port to monitor error messages through the serial
connection. If the serial port is no longer required, use the
logout command to log
out of the serial console, remove the serial cable, and replace the plug in the serial
port.
Chapter 3. Starting and configuring the SAN768B-2
35