IBM SAN768B-2, Installation, Service And User Manual

Page: 102 / 186

2. Adjust the ejectors to the open position, align the flat side of the blade inside
the upper and lower rail guides in the slot, and slide the blade into the slot
until it is firmly seated.Adjust the ejectors to the open position, align the flat
side of the blade inside the upper and lower rail guides in the slot, and slide
the blade into the slot until it is firmly seated.
3. Adjust the ejectors to the closed position by pulling them away from the center
of the blade.
4. Tighten the upper and lower thumbscrews using the Phillips screwdriver.
5. Verify that the power LED on the blade displays a steady green light (it might
require a few seconds to turn on). If it does not turn on, ensure that the blade
is firmly seated.
6.
The Status LED on the blade will show amber until POST completes for the
blade. It should then display green. If it remains amber, the board may not be
properly seated in the backplane or the board may be faulty.
7. Install the transceivers and cables in the blade. For mSFP transceivers (FC8-64
port blade only), it is recommended that you install the cables in the
transceivers before installing the transceivers in the blade.
8. Group and route the cables through the cable management comb.
9. Install the chassis door.
Removing and installing blade filler panels
This section describes how to remove and install port blade filler panels.
Note: Some filler panels have two thumbscrews and some have only one. Be sure
to unscrew or tighten both if you are using the two-screw version.
Removing a filler panel
Attention: A filler panel should be removed only when being replaced with a
port or application blade or new filler panel. Any slot that is not occupied by a
blade should be occupied by a filler panel to ensure correct cooling of the chassis
and protection from dust.
Complete the following steps to remove a filler panel.
1. Remove the chassis door.
2.
Unscrew the thumb screws on the panel using a Phillips screwdriver.
3. Using the tabs, pull the filler panel out of the chassis. (See Figure 26 on page
73.)
72
SAN768B-2 Installation, Service, and User Guide