IBM SAN768B-2, Installation, Service And User Manual

Page: 138 / 186

11. Power-on the chassis “Providing power to the SAN768B-2” on page 33.
The system performs a power-on self-test (POST). The POST takes a minimum
of three minutes and is complete when LED activity returns to standard state.
12.
Verify that the POST is complete. All power LED indicators on the port,
control processor, and core switch blades should be a steady green.
13. Verify that all components are functioning correctly by checking their LEDs. If
the LEDs do not indicate correct operation, try reinstalling the corresponding
component.
Downloading the configuration
Once the chassis and its various components have been reassembled and powered
back on, use the
configDownload
command to restore the original configuration.
The
configDownload
command can be entered through a Telnet or serial session,
but the chassis must have an Ethernet connection to the server name or IP of the
host for the download process to complete. For more information, refer to the
help
configdownload command or the Fabric OS Command Reference Manual .
Complete the following steps to download the configuration.
1. Log in to the chassis as admin:
switch:admin> login
login: admin
password: xxxxxxxx
switch:admin>
Note:
If you are using the Virtual Fabric feature, you should run
configdownload -vf before running the configdownload command in
order to restore the logical switch configuration.
2. Enter configDownload command:
switch:admin> configdownload -all
Server Name or IP Address [host]: 123.123.123.123
User Name [None]: Admin24
File Name [config.txt]: config-switch.txt
Password: xxxxxxxx
download complete
switch:admin>
3. Reboot the system.
Verifying the correct operation of the system
Complete these steps to verify that the hardware is operating correctly.
1.
Log in to the SAN768B-2 as
admin
:
switch:admin> login
login: admin
password: xxxxxxxx
switch:admin>
2. Enter the slotShow -m command and verify that all the installed cards are
detected and that their status is operational (enabled).
switch:admin> slotShow -m
Slot Blade Type ID Model Name Status
--------------------------------------------
1
SW BLADE 97 FC16-32 ENABLED
2 SW BLADE 77 FC8-64 ENABLED
3 SW BLADE 97 FC16-32 ENABLED
4 SW BLADE 97 FC16-32 ENABLED
5 CORE BLADE 99 CR16-8 ENABLED
6 CP BLADE 50 CP8 ENABLED
108
SAN768B-2 Installation, Service, and User Guide