IBM SAN768B-2, Installation, Service And User Manual

Page: 139 / 186

7 CP BLADE 50 CP8 ENABLED
8 CORE BLADE 99 CR16-8 ENABLED
9 SW BLADE 96 FC16-48 ENABLED
10 SW BLADE 77 FC8-64 ENABLED
11 SW BLADE 96 FC16-48 ENABLED
12 SW BLADE 77 FC8-64 ENABLED
switch:admin>
3. Verify that the SAN768B-2 is functioning correctly by entering switchShow or
switchStatusShow . The switchShow command displays chassis and port status
information.
switch:admin> switchshow
switch:FID128:root> switchshow
switchName: SAN768B-2_8
switchType: 120.1
switchState: Online
switchMode: Native
switchRole: Subordinate
switchDomain: 80
switchId: fffc50
switchWwn: 10:00:00:05:1e:39:e4:5a
zoning: ON (ZONE_CONFIG_NAME)
switchBeacon: OFF
FC Router: OFF
Allow XISL Use: OFF
LS Attributes: [FID: 128, Base Switch: No, Default Switch: Yes, Address Mode
0]
Index Slot
Port Address Media Speed State Proto
===========================================================
0
1 0 500000 -- 4G No_Module FC
1 1 1 500100 -- 4G No_Module FC
2 1 2 500200 -- 4G No_Module FC
3 1 3 500300 -- 4G No_Module FC
4 1 4 500400 -- 4G No_Module
<output truncated>
4. Verify that all the IP address information is correct by entering the
ipAddrShow command and checking the results against the IP information
recorded in the config-miscinfo.txt file.
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: xxx.xxx.xxx.12
Ethernet Subnetmask: 255.55.0.0
Fibre Channel IP Address: 1.2.3.4
Fibre Channel Subnetmask: 255.255.255.0
CP0
Ethernet IP Address: xxx.xxx.xxx.10
Ethernet Subnetmask: 255.55.0.0
HostName : cp0
Gateway Address: xxx.xxx.xxx.1
CP1
Ethernet IP Address: xxx.xxx.xxx.11
Ethernet Subnetmask: 255.55.0.0
HostName : cp1
Gateway Address: xxx.xxx.xxx.1
Backplane IP address of CP0 : 10.0.0.5
Backplane IP address of CP1 : 10.0.0.6
switch:admin>switch:admin>
Chapter 5. Removing and installing components
109