IBM SAN768B-2, Installation, Service And User Manual

Page: 54 / 186

15. Remove the retention straps.
16.
Slide the SAN768B-2 into the cabinet until it rests securely on the shelf
brackets.
17. Remove the wheel chocks, release the wheel brake, and move the lift tool
away from the cabinet.
18. Uninstall the bridge tool and return it to its original box.
19. Reinstall the power supplies and blower assemblies if any were removed.
20. Fasten the port side of the chassis to the cabinet rails. Use three 10–32 x
5/8-in. Phillips panhead screws with washers
C
on each side to attach to the
clip nuts (
D
) or retainer nuts (
F
) installed on the rails earlier. Tighten the
screws to a torque of 37 cm-kg (32 in-lb). See Figure 9 for the approximate
location of the screws.
Note: Do not use the top or bottom holes of the SAN768B-2 mounting
brackets because the screw heads will interfere with the chassis door.
21. Reinstall the cable management comb, if it was removed (see “Removing and
installing a cable management comb” on page 68).
22. If ICL cables will not be used, ensure that the ICL sockets in the core switch
blades have EMI plugs inserted.
23. Reinstall the chassis door. Align the door with the chassis and push it into
place, as shown in Figure 10 on page 25 and Figure 11 on page 26.
b768ig031
Figure 9. Attaching the port side of the chassis to the cabinet rails
24
SAN768B-2 Installation, Service, and User Guide