IBM SAN768B-2, Installation, Service And User Manual

Page: 48 / 186

Note: The standard packaging does not incorporate a wood pallet and pallet
brackets. The chassis sits on top of a plastic shipping tray.
5.
Use the lift tool to transport the new chassis to the installation area. Doorways
must be wider than 91 cm (36 in.) to accommodate the chassis on the shipping
tray.
Attaching the shelf brackets
Complete the following steps to install the shelf brackets to the cabinet rails:
1. Find the left and right rack mount shelf brackets (
A
and
B
in Figure 4) in
the 14U rack mount kit. These brackets are adjustable to allow for different
cabinet depths.
2. Loosen the adjusting screws on both brackets enough to allow the brackets to
slide easily to adjust the length.
3. Position the shelf brackets (
A
and
B
) with the adjustable ends at the intake
aisle side of the cabinet (see Figure 4) and attach them to the cabinet rails.
v
For rails with round holes: Use eight screws with lock washers (
E
) for each
bracket, four at each end. Tighten the screws to a torque of 92 cm-kg (80
in.-lb).
v
For rails with square holes: Use eight screws (
G
) eight alignment washers
(
H
) for each bracket, four at each end. Tighten the screws to a torque of 92
cm-kg (80 in.-lb).
(4x)
(4x)
E
E
A
B
G
H
(4x)
E
(4x)
E
(4x)
(4x)
(4x)
(4x)
Aisle
Intake
Air
Rail
Aisle Exhaust
Air
Shown with
Round Hole Rails
Setup for rails with square holes
Adjustable ends
b768ig028
Figure 4. Left and right shelf brackets installed on the cabinet rails
18
SAN768B-2 Installation, Service, and User Guide