IBM SAN768B-2, Installation, Service And User Manual

Page: 117 / 186

If the SAN768B-2 will continue operating during the replacement, check the
power LEDs to verify that the minimum number of power supplies is
functioning. See “Power specifications” on page 127 to determine your power
requirements.
2. Turn off the power switch.
3. Remove the power cord.
4. Loosen the thumbscrew.
5. Grasp the handle and pull, sliding the power supply from the chassis,
supporting the power supply from beneath as you remove it. (see Figure 30).
6. If you are not replacing the power supply, insert a filler panel into the slot.
Installing a power supply
Complete these steps to install a power supply.
1. Remove any filler panels.
2. Insert the power supply into the slot. Verify that the power supply is seated by
gently pulling on the handle. The power supply should resist movement as you
pull.
b768ig003
Figure 30. Removing and installing a power supply
Chapter 5. Removing and installing components
87