IBM SAN Volume Controller, Hardware Maintenance Manual

Page: 47 / 334

Table 19. Cable-management arm and associated parts descriptions and quantities
Reference Description Quantity
1
Slide rail (left) 1
2
Slide rail (right) 1
3
Large cable tie 1
4
Cable ties 5
5
M6 screws 4
6
10-32 screws 2
7
Cable-management support arm 1
8
Cable-management arm mounting bracket 1
9
Cable-management arm stop bracket 1
10
Cable-management arm assembly 1
The cable-management arm is installed to pivot from the left side of the SAN Volume Controller
2145-CF8 rack.
To remove the cable-management arm, perform the following steps:
1.
Remove all power from the node, as described in MAP 5350 in the IBM System Storage SAN Volume
Controller 2145 Troubleshooting Guide .
2. Disconnect all cables from the back of the SAN Volume Controller 2145-CF8 node.
3.
Slide the SAN Volume Controller 2145-CF8 away from the back of the rack.
a. Remove any optional M6 screws, as shown by
1
in Figure 9 on page 22, from the front of the
node.
b. To release the node from the rack, press the orange release latches
2
and slide the SAN Volume
Controller 2145-CF8 node forward until it latches in the service position.
5
6
7
8
9
10
1
2
3
4
svc_bb1ka200
Figure 8. SAN Volume Controller 2145-CF8 cable-management arm, support rails, and associated parts
Chapter 2. Removing and replacing parts
21