IBM Netfinity 5100 8658 21Y, Manual

Page: 42 / 246

Table 3. NDIS 2.01 (OS/2) driver messages for the
Ethernet controller (continued)
PCNTND-23 WARNING: PCNET IRQ found = xx
Explanation: The interrupt request (IRQ)
setting ( xx ) in the PROTOCOL.INI file does
not match the hardware IRQ setting. Action:
Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ setting
in the PROTOCOL.INI file to match the IRQ
setting shown in the
PCI Slot/Device
Information selection of the Advanced Setup
menu in the Configuration/Setup Utility
program.
PCNTND-24 WARNING: PCNET IRQ does not match
PROTOCOL.INI.
Explanation: The interrupt request (IRQ)
setting in the PROTOCOL.INI file does not
match the hardware IRQ setting.
Action:
Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ setting
in the PROTOCOL.INI file to match the IRQ
setting shown in the
PCI Slot/Device
Information selection of the Advanced Setup
menu in the Configuration/Setup Utility
program.
PCNTND-25 PCI scan specified, PCI bus not found!
Explanation: The driver cannot locate the PCI
bus. Action: Run the diagnostic programs.
PCNTND-29 WARNING: DMA number is not necessary for
PCI device.
Explanation: The Ethernet controller does not
require a DMA setting. Action: Remove the
DMA setting in the PROTOCOL.INI file.
PCNTND-33 PCNET device with specified IOBASE is
already in use.
Explanation: The specified I/O address
number is already in use by another Ethernet
controller or device.
Action: Remove the I/O
address setting in the PROTOCOL.INI file.
NDIS 4.0 (Windows NT) driver
messages
This section contains the error messages for the NDIS 4.0
drivers. The explanation and recommended action are
included with each message.
32
: Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y,
41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY