IBM Netfinity 5100 8658 21Y, Manual

Page: 22 / 246

v If the server is activated and a power failure occurs, the
server will start automatically when power is restored.
v
Pressing the Reset button resets the server and runs
the power-on self-test.
v The server can also be powered on by the Netfinity
Advanced System Management Processor.
Deactivating the server
The server can be deactivated as follows:
CAUTION:
The power control button on the device and/or the
power switch on the power supply do not turn off the
electrical current supplied to the device. The device
also might have more than one power cord. To remove
all electrical current from the device, ensure that all
power cords are disconnected from the power source.
1
2
v You can turn off the server by pressing the Power
control button on the front of the server. Pressing the
Power control button starts an orderly shutdown of the
operating system, if this feature is supported by your
operating system, and places the server in standby
mode.
Note: After turning off the server, wait at least 5
seconds before pressing the Power control button
to power the server on again.
v You can press and hold the Power control button for
more than 4 seconds to cause an immediate shutdown
of the server and place the server in standby mode.
This feature can be used if the operating system hangs.
v You can disconnect the server power cords from the
electrical outlets to shut off all power to the server.
Note: Wait about 15 seconds after disconnecting the
power cords for your system to stop running.
12
: Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y,
41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY