IBM Netfinity 5100 8658 21Y, Manual

Page: 179 / 246

Error symptoms
Error Symptom FRU/Action
CD is not working
properly.
1. Clean the CD.
2. Run CD-ROM Diagnostic
3. CD-ROM Drive
CD-ROM drive tray is
not working.
(The
server must be
powered-on.)
1. Insert the end of a paper clip into
the manual tray-release opening.
2. Run CD-ROM Diagnostic
3. CD-ROM Drive
CD-ROM drive is not
recognized.
1. Run Configuration/Setup, enable
primary IDE channel.
2. Check cables and jumpers.
3. Check for correct device driver.
4. System Board
5. Run CD-ROM diagnostics
6. CD-ROM Drive
Power switch does
not work and reset
button does work.
1. Verify that the power-on override
switch 5 of SW1 is set to Off (see
“System board switches and
jumpers” on page 57).
2. Power Switch Assembly
3. System Board
Diskette drive in-use
light stays on, or the
system bypasses the
diskette drive, or the
diskette drive does
not work.
1. If there is a diskette in the drive,
verify that:
a. The diskette drive is enabled in
the Configuration/Setup utility
program.
b. The diskette is good and not
damaged. (Try another diskette
if you have one.)
c. The diskette is inserted correctly
in the drive.
d. The diskette contains the
necessary files to start the
server.
e. The software program is OK.
f. Cable is installed correctly
(proper orientation)
2. Run Diskette Drive Diagnostics.
3. Cable
4. Diskette Drive
5. System Board
Symptom-to-FRU index
169