IBM Netfinity 5100 8658 21Y, Manual

Page: 185 / 246

Error Code/Symptom FRU/Action
1304 (I
2
C cable to
diagnostic LED board not
found)
1. Cable
2. Diagnostic LED Board
3. Power Switch Assembly
4. System Board
1600 (The Service
Processor is not
functioning) Do the
following before replacing
a FRU:
1. Ensure that a jumper
is not installed on
J51.
2. Remove the ac
power to the system,
wait 20 seconds;
then, re-connect the
ac power. Wait 30
seconds; then,
power-on the system.
1. System Board
1601 (The system is able
to communicate to the
Service Processor, but
the Service Processor
failed to respond at the
start of POST.) Do the
following before replacing
a FRU:
1. Remove the ac
power to the system,
wait 20 seconds;
then, re-connect the
ac power. Wait 30
seconds; then,
power-on the system.
2. Flash update the
Service Processor.
1. System Board
1762 (Fixed Disk
Configuration error)
1. Fixed Disk Cables
2. Run Configuration/Setup 2
3. Fixed Disk Adapter
4. Fixed Disk Drive
5. SCSI Backplane
6. System Board
178X (Fixed Disk error)
1. Fixed Disk Cables
2. Run Diagnostics
3. Fixed Disk Adapter
4. Fixed Disk Drive
5. System Board
Symptom-to-FRU index
175