IBM Netfinity 5100 8658 21Y, Manual

Page: 40 / 246

Table 2. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller (continued)
PCNTNW-NW-164 The device was not found.
Explanation: The driver cannot find an
Ethernet controller in the server. Action:
Verify that the Ethernet controller is
enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic
programs” on page 21 to run the diagnostic
programs.
PCNTNW-NW-165 The device was not found at IOADDRESS.
Explanation: The Ethernet controller
cannot be found at the I/O address
specified.
Action: The Ethernet controller
does not require a parameter for the I/O
address. Remove the I/O address
parameter.
PCNTNW-NW-167 PCI scan specified, device not found.
Explanation: The driver cannot locate the
Ethernet controller on the PCI bus. Action:
Verify that the Ethernet controller is
enabled. If the problem persists, go to
“Starting the diagnostic programs” on
page 21 to run the diagnostic programs.
PCNTNW-NW-180 The DMA parameter is not necessary for
PCI device.
Explanation: The Ethernet controller does
not require a DMA setting. Action: None
necessary, message is for information only.
Network driver interface specification
2.01 (OS/2) driver messages
This section provides explanations of the error messages
for the NDIS 2.01 (OS/2) drivers, and suggested actions to
resolve each problem.
Table 3. NDIS 2.01 (OS/2) driver messages for the
Ethernet controller
PCNTND-1 Unable to open the Protocol Manager .
Explanation: The NDIS stack is not
configured correctly. Action: Check and
correct your configuration.
PCNTND-6 Out of memory while allocating buffers.
Explanation: The driver could not allocate the
requested buffers. Action: Check your system
configuration. Edit the PROTOCOL.INI file to
reduce the number of Txbuffers and Rxbuffers
specified for the driver.
30
: Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y,
41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY