IBM Netfinity 5100 8658 21Y, Manual

Page: 98 / 246

5
Filler panel
To install a hot-swap power supply:
1. Remove the filler panel from the empty power supply
bay by inserting your finger into the depression on the
filler panel and pulling it away from the server. Save
the filler panel in case you remove the power supply at
a later time.
Note: During normal operation, each power-supply bay
must have either a power supply or filler panel
installed for proper cooling.
2. Install the power supply in the bay:
a. Place the handle on the power supply in the open
position (that is, perpendicular to the power supply)
and slide the power supply into the chassis.
b. Gently close the handle to seat the power supply in
the bay.
3. Plug the power cord for the added power supply into
the power cord connector.
4. Route the power cord through the cable-restraint
bracket.
5. Plug the power cord into a properly grounded electrical
outlet.
6. Verify that the DC Power light and AC Power light on
the power supply are lit, indicating that the power
supply is operating correctly.
7. If you have other options to install or remove, do so
now; otherwise, go to“Installing the cover” on page 92.
Removing a hot-swap power supply
Attention: If you have not installed the power supply
backplane option, you have only one power supply, which
is not hot-swappable. To remove the single power supply,
or the only remaining hot-swap power supply, go to
“Removing the only power supply” on page 89. Otherwise,
continue with the following procedure.
To remove a hot-swap power supply:
1. If the NON LED on the diagnostic LED panel is lit, turn
off the server and peripheral devices; otherwise, go to
the next step.
2. Remove the power supply:
a. Unplug the power cord connector from the power
supply.
Attention: Be careful when you remove the
hot-swap power supply; the power supply might be
too hot to handle comfortably.
88
: Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y,
41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY