IBM Infoprint 6500-v05, Maintenance Manual

Page: 482 / 544

482
27. Install finger tight the 10-32 x 5/32 inch buttonhead screw and washer securing the right vertical rail to the upper frame
cross-member. (Figure 78.)
28. Move the elevator assembly up and down on the vertical rails until it travels smoothly with no binding.
29. Tighten the two 10-32 x 5/32 inch buttonhead screws securing the vertical rails to the upper frame cross-member.
30. Pull the paper tray out until the holes in the rails permit access to the M3x6 screws. Tighten the M3 screws securing the
vertical rails to the stacker base. Each rail is secured by two screws. (Figure 72.)
31. Move the elevator assembly up and down and make sure it travels smoothly with no binding. If the elevator binds or
catches anywhere along its path of travel, slightly loosen the upper rail screws and repeat steps 28 and 29 until the elevator
moves smoothly.
32. Bundle the stacker operator panel cables in the wire saddles located under the card cage. Tie wrap the cables so they do
not catch in the stacker mechanism as it moves up and down. Route the stacker rail and frame cables so they move without
snagging as the elevator assembly moves up and down. (Figure 79.)
Figure 79. This figure shows how to bundle and route the stacker cables beneath the card cage and behind the
operator panel.
Cutout Beneath
Card Cage Fan
Wire Saddle