IBM eServer xSeries 235 Type 8671, Maintenance & Troubleshooting

Page: 154 / 214

Note: See “System” on page 156 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
962 (Parallel port error)
1. Disconnect the external cable on the parallel port.
2. Run the Configuration/Setup Utility program.
3. System board.
11XX (System board serial port 1 or 2
error)
1. Disconnect the external cable on the serial port.
2. Run the Configuration/Setup Utility program.
3. System board.
1301 (I
2
C cable to front panel not found)
1. Cable
2. Front panel
3. Power switch assembly
4. System board
1302 (I
2
C cable from system board to
power on and reset switches not found)
1. Cable
2. Power switch assembly
3. System board
1303 (I
2
C cable from system board to
power backplane not found)
1. Cable
2. Power cage assembly, if installed
3. System board
1304 (I
2
C cable to diagnostic LED board
not found)
1. Power switch assembly
2. System board
1600 (The system management processor
is not functioning) Do the following before
replacing a FRU:
1. Ensure that a jumper is not installed
on J34.
2. Remove the ac power to the server,
wait 20 seconds; then, reconnect the
ac power. Wait 30 seconds; then, turn
on the server.
v System board
1601 (The system is able to communicate
to the system management processor, but
the system management processor failed
to respond at the start of POST.) Do the
following before replacing a FRU:
1. Remove the ac power to the server,
wait 20 seconds; then, reconnect the
ac power. Wait 30 seconds; then, turn
on the server.
2. Flash update the system management
processor.
1. Remote Supervisor Adapter, if installed
2. System board
1602 (Cable for optional service processor
adapter not installed)
v Disconnect all server and option power cords from server, wait
30 seconds, reconnect, and retry.
144
xSeries 235 Type 8671: Hardware Maintenance Manual and Troubleshooting Guide