IBM eServer xSeries 235 Type 8671, Maintenance & Troubleshooting

Page: 118 / 214

SCSI connectors
The following illustration shows the 68-pin, female D-shell SCSI connectors. These
connectors conform to the SCSI standard.
34 1
68 35
Serial ports
Your server has one standard serial port that the operating system can use.
Some application programs require specific ports, and some modems function
properly only at certain communication-port addresses. You might need to use the
Configuration/Setup Utility program to change communication-port address
assignments to prevent or resolve address conflicts.
Viewing or changing the serial-port assignments
To view or change the serial-port assignments:
1. Restart the server and watch the monitor screen.
2. When the message
Press F1 for Configuration/Setup
appears, press F1.
3. From the main menu, select Devices and I/O Ports ; then, press Enter.
Note: The Devices and I/O Ports choice appears only on the full configuration
menu. If you set two levels of passwords, you must type the
administrator password to access the full configuration menu.
4. Select the serial port; then, use the arrow keys to advance through the settings
available.
5. Select Save Settings ; then, select Exit Setup to exit from the
Configuration/Setup Utility main menu.
Serial-port connectors
The following illustration shows the 9-pin, male D-shell serial-port connector on the
rear of your server. This connector conforms to the industry standard.
1
5
6 9
108
xSeries 235 Type 8671: Hardware Maintenance Manual and Troubleshooting Guide