IBM eServer xSeries 235 Type 8671, Maintenance & Troubleshooting

Page: 105 / 214

7. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
the battery clip holds the battery securely.
8. Reinstall the adapter-support bracket in the server (see “Removing and
installing the adapter-support bracket” on page 54).
Note: You must reinstall the air-baffle assembly when you reinstall the
adapter-support bracket. Make sure that no cable is under the
adapter-support bracket or interferes with the center fans (connector
J18).
Important: To ensure proper cooling and server operation, you must keep the
air-baffle cover closed.
9. Reinstall the adapters and plastic dividers that you removed, and reconnect
the internal cables that you disconnected.
10. Reinstall the server cover (see “Installing the server bezel and left-side cover
(tower model)” on page 96 or “Installing the server bezel and top cover (rack
configuration)” on page 99).
Note: You must wait approximately 20 seconds after you plug the power cord
of your server into an electrical outlet before the power-control button
becomes active.
11. Start the Configuration/Setup Utility program and set configuration parameters
as needed (see “Starting the Configuration/Setup Utility program” on page 12).
Completing the installation
To complete your installation, you must reinstall the bezel, reinstall the server cover,
reconnect all the cables that you disconnected earlier and, for certain options, run
the Configuration/Setup Utility program. Follow the instructions in this section.
Attention:
v For proper cooling and airflow, replace the server cover before or shortly after
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the server cover removed might damage server components.
v
To ensure proper server operation, do not remove the air-baffle assembly from
the server except when installing or removing the components that are under the
air-baffle cover.
Note: If you have just plugged the power cords of your server into electrical outlets,
you will have to wait approximately 20 seconds before pressing the
power-control button.
Chapter 4. Customer replaceable units
95