IBM eServer xSeries 235 Type 8671, Maintenance & Troubleshooting

Page: 63 / 214

Removing the server top cover and bezel (rack configuration)
This section describes how to remove the top cover and bezel from a rack
configuration server.
Removing the top cover
The following illustration shows how to remove the top cover from a rack
configuration server.
Top cover
Left-side latch
Right-side
latch
Cover-release latch
C
PU
VR
M
M EM
OR
Y
H D
D
PCI
B
U S
N
M
I
SM
I
SER
VIC
E
PR
OC
ES
SOR
BU
S
N O
N RE
D U
ND
AN
T
PO
W
ER
SU
PPL
Y
1 2
3
A
B
1
2
3
FA
N
TEM
PE
RA
TU
R E
Complete the following steps to remove the server top cover:
1. Review the information in “Installation guidelines” on page 41, “Handling
static-sensitive devices” on page 42, and “Safety information” on page 163.
2. Press down on the plastic cover-release latch on the front of the server.
3. While pressing the plastic cover-release latch, slide the top cover slightly toward
the rear of the server; the cover will stop after approximately 25 mm (1 inch).
Release the cover-release latch; then, lift the cover off the server and set the
cover aside.
Chapter 4. Customer replaceable units
53