IBM 4400-006 - 4400 Model 006 B/W Direct Thermal, User Manual

Page: 269 / 326

Set Commands
269
set logpath logpath type [[-]job] [[-]user] [[-]pgcnt]
[[-]cksum] [[-]printer] [[-]ioport]
example:
set logpath l2 type job user printer pgcnt
Establish the type of printer and print job logging to be done
within this
logpath
. The options are:
job Job ID, username, etc.
user User ID along with three messages per job
about start and finish.
pgcnt For total pages printed in a job.
cksum 16-bit checksum value to confirm integrity of
data printed.
printer For special printer feedback.
ioport Printer error messages determined through
the parallel port pins.
set logpath logpath port TCPportnumber| email|syslog
example:
set logpath l3 port 2000
Determine where the log information should be sent for a print
job or attached printer. The choices are:
TCPportnumber
TCP port number ranging from 1024 to
65000.
SMART
email Particular user's email address. This address
is set using the
set sysinfo email
emailname@IPaddress
command.
syslog A central TCP/IP host running the SYSLOG
daemon. This host is set using the
set
sysinfo syslog IPaddress
command.
set logpath from default
Set all logpath settings back to factory defaults.
set logpath from stored
Set all current logpath settings to the values stored in flash
memory.