IBM 4400-006 - 4400 Model 006 B/W Direct Thermal, User Manual

Page: 127 / 326

Front Panel Message - Dynamically Set Params Read Only
127
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway
parameters to the desired values.
SMART
12. If the Web browser access does not work,
telnet
into the
Ethernet Interface as
root
. Enter the following command:
config http on
Front Panel Message - Dynamically Set Params
Read Only
SMART
This is not an error. It is an informational message warning that the
IP address has been dynamically set by dhcp, rarp, or bootp.
To assign a static IP address, turn off the rarp, bootp, and dhcp on
the adapter. Use the following procedure:
1. Telnet to the adapter. Login = root, password = (Enter key)
Telnet commands are:
store tcpip 1 opts -rarp -bootp -dhcp
reset
Wait 30 seconds minutes for the adapter to reset.
2. Program the IP address, Subnet Mask, and Gateway (if
required) from the front panel.