3-12 Operation
If the machine needs to be stored for
a long time, operate according to the
following requirements:
A. Before storage
●
Wash each part of the vehicle, dry and store in a dry
warehouse. If the machine is only allowed to be stored in
the open, it is necessary to park the machine on the con-
crete road surface where the drain is easy, and use the
canvas to cover.
●
Before storage, the fuel tank must be filled with fuel, and
fill lubrication grease to each movable axis pin, propeller
shaft, and replace hydraulic oil.
●
Put the shifting manipulating handle on “Neutral Gear”
position, and put the shifting manipulating Neutral Gear
locking plate on “Locking” position.
●
Pull up the handle of parking brake to apply parking
braking.
●
Put the bucket on a flat ground, and toggle the working
device handle to the middle position.
●
Toggle each switch to middle position or “OFF”, and lock
all doors.
●
Coat a thin layer of grease on the open part of the piston
rod of the hydraulic cylinder.
●
Remove battery from the vehicle, and store it separately.
●
Air temperature decreases to below 0℃, add anti-freeze
fluid into cooling water for engine, and make anti-freeze
fluid able to access engine body and A\C system radia
-
tor. Or you can drain out the water in the cooling system.
Pay attention that you should also drain out the water in
the radiator of A\C system.
●
After the machine is fixed, use frame-fixed bumper to fix
the front and rear frames.
Summary of Contents for HL630VL
