![background image](http://html1.mh-extra.com/html/hyundai/hl630vl/hl630vl_operators-manual_2196161100.webp)
Operation 3-9
5. Check service braking performance of the vehicle. Drive
the machine at gear Forward I or II on the flat ground. First
release the throttle pedal and smoothly depress the service
brake pedal, then the machine can obviously slow down
and stop.
Note :
If you depress the service brake pedal, but feel that
the machine cannot obviously slow down, please
immediately pull up parking brake handle to apply
the braking. Meanwhile, operate the manipulating
handle to lower down the arm to the lowest position,
and tilt the bucket forward to make the bucket lip or
knife edge insert in or go against the ground to force
the machine to stop, thus ensure the security.
6. Check the engagement statues of each gear. Drive the
machine to the flat ground. Check the gear shifting of the
machine respectively with combination of each gear.
7. Steering operation of the machine:
When the machine needs to turn due to the bend ahead in
the driving direction, please perform the operation follow-
ing the local traffic laws and regulation. At time when you
are about to make a turn, you should first put the control
handle of the steering lamp to the corresponding direction.
When the combo switch handle is toggled forward, it is to
turn leftwards, and when it is toggled backward, it is to turn
rightwards. At this time, the steering lamps on correspond-
ing side in front of or at the rear of the machine and the
corresponding steering indicators on the panel will flash,
indicating to the adjacent vehicles and pedestrians around
that this machine will implement the steering operation.
Then, rotate the steering wheel towards the side you want
to make a turn, and the steering immediately begins.
This machine adopts hinged-type full-hydraulic coaxial
flow amplifying power steering. The steering wheel rotation
angle is not equal to the machine’s rotation angle. Contin-
uously rotate the steering wheel to increase the rotation
angle until to the required position. The quick the steering
wheel rotates, the quick the machine rotates.
Summary of Contents for HL630VL
