OPeRATION
powermax
65/85
Operator Manual
4-11
Attach the work clamp to the workpiece
The work clamp must be connected to the workpiece while you are cutting. If you are using the
Powermax65 or Powermax85 with a cutting table, you can connect the work lead directly to
the table instead of attaching the work clamp to the workpiece. See your table manufacturer’s
instructions.
Note the following:
• Ensure that the work clamp and the workpiece make good metal-to-metal contact.
Remove rust, dirt, paint, coatings, and other debris to ensure the power supply makes
proper contact with the workpiece.
• For the best cut quality, attach the work clamp as close as possible to the area being cut.
•
Do not attach the work clamp to the portion of the workpiece to be cut away.
Work clamp
Summary of Contents for Powermax 65
Page 1: ...Plasma arc cutting systems Operator Manual 806650 Revision 0 85 ...
Page 10: ...Table of Contents vi powermax65 85 Operator Manual WARRANTY vi Hypertherm ...
Page 30: ...Specifications 1 16 powermax65 85 Operator Manual ...
Page 140: ...Maintenance and Repair 5 12 powermax65 85 Operator Manual ...
