SHOCK ABSORBER, LINK FORK 9
•-
-•
-
Check needle bearings
C,
and
0
for damage and wear.
If there is damage or wear:
-
Change the needle bearings.
-
Check spacers (3 and @ for damage and wear.
If there is damage or wear:
-
Change the spacers.
-
Check the shaft seal rings for damage and wear.
If there is damage or wear:
-
Change the shaft seal rings.
-
Check dimension f).
303096-10
I
54.91 ... 55.00 mm (2.1618 ... 2.1654 in)
If dimension f) is below the specified value:
- Add the necessary spacing washers
@).
-
Position the angle lever.
-
Mount fitting
8
but do not tighten yet.
Guideline
Nut, angle lever to
link fork
M14x1 .5
80 Nm (59 lbf ft)
63
