
Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-15
View
Interface view
Parameter
None
Description
Use the
rip split-horizon
command to configure an interface to use split horizon when
transmitting RIP packets.
Use
undo rip split-horizon
command to configure an interface not to use split horizon
when transmitting RIP packets.
By default, an interface is enabled to use split horizon when transmitting RIP packets.
Normally, split horizon is necessary for reducing route loop. Only in some special cases,
you need to disable split horizon to ensure the correct execution of protocols. When
doing that, make sure that it is necessary.
Example
# Specify the interface Vlan-interface 10 not to use split horizon when processing RIP
packets.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] undo rip split-horizon
2.1.19 rip version
Syntax
rip version 1
rip version 2
[
broadcast | multicast
]
undo rip version
View
Interface view
Parameter
1
: Version of RIP packets on an interface is RIP-1.
2
: Version of RIP packets on an interface is RIP-2.
broadcast
: Transmission mode of RIP-2 packet is broadcast.
multicast
: Transmission mode of RIP-2 packet is multicast.