HP Workstation xw3100, Service And Technical Reference Manual

Page: 139 / 148

Service and Technical Reference Guide, xw3100 G–1
G
Ultra ATA Drive Guidelines and Features
Ultra ATA Jumpers
Ultra ATA drives are configured by means of jumper settings. Factory-installed drives ship with
the jumpers preset to the cable-select mode; therefore, no jumper setting changes are required on
factory pre installed, replacement, or option drives. With cable-select, the drive is configured as
either Master (Drive/Device 0) or Slave (Drive/Device 1) by its physical attachment to the cable.
If you purchase a third-party hard drive, refer to the documentation included with the drive kit to
ensure proper cable installation and configuration.
✎
All drives on a controller channel need to have their jumpers either in the cable-select mode or
have the individual drive jumper installed on the appropriate Master (Drive/Device 0) or Slave
(Drive/Device 1) position.
Ultra ATA Cables
When installing a second device on either the primary or secondary controller, you must use an
industry standard 80-conductor Ultra ATA cable for optimal performance. These cables have a
maximum length of 18 inches and a maximum distance of 6 inches between the two devices for a
two-drive cable.
Drives operating at speeds faster than those of the Ultra ATA-33 devices require
industry-standard 40-pin, 80-conductor cables to maintain the higher data transfer rates possible
with the improved technology.
When using Ultra ATA-133, -100, -66, and slower -33 drives in the same system, each drive will
operate at its appropriate data transfer rate.
Cable Layout
The faces of industry-standard cable connectors are color coded for easy recognition:
■
System board connector = blue face
■
Device 0 connector = black face
■
Device 1 connector = gray face
✎
The color code of an industry-standard cable is valid only if the drive’s jumper is in the
cable-select position.