4.
The following message is displayed:
Please close Mailslot(s)
. Remove the existing tape
cartridges from the mailslot and insert new tape cartridges, as required.
5.
Push the mailslot back into the library.
Moving Media (Operations > Move Media)
This option instructs the library to move a cartridge from a tape drive, a tape slot in any magazine
or the mailslot in the left magazine to any other location not already holding a tape. This option
also lets you load and unload tape cartridges to and from the installed tape drives. To use this
command, you must first select where you want to move the tape from (in one of the Source
fields), and then indicate where you want to move the tape to (in one of the Destinations fields).
Source Type
: This toggles between all available sources: mailslot, magazines, and the active
drives.
Source -> Source by Label
: If appropriate, this toggles between available source cartridges. In
the following example, the source type is a magazine, so you need to select a cartridge from the
magazine. You can do this by selecting a specific slot (Source field) or specifying the target
cartridge's barcode (Source by Label field). Only Full source slots are available for selection.
Destination Type
: This toggles between all available destinations: Mailslot, Magazine and Drive.
Destination
: If appropriate, this option allows you to specify the cartridge destination. For a
magazine, select a slot. Only Empty destination slots are available for selection.
Access to the
Move Media
option requires the use of the administrator password.
To move a tape in the library:
1.
Highlight
Operations ->
Move Media and press
OK
to select it.
Figure 74 Operations menu
2.
Enter the administrator password if prompted.
3.
Use the Up and Down arrows to move to the
Source Type
field and press
OK
.
4.
Use the Up and Down arrows to change the value of the highlighted field. When the
highlighted field shows the desired value, press
OK
to select.
5.
If appropriate, move to the
Source
field and press
OK
. Repeat step 4 to specify the source
cartridge.
6.
Use the Up and Down arrows to move to the
Destination Type
field and press
OK
.
7.
Use the Up and Down arrows to change the value of the highlighted field. When the
highlighted field shows the desired value, press
OK
to select.
8.
If appropriate, move to the
Destination
field and press
OK
. Repeat step 7 to specify the
cartridge destination
Using the MSL4048, MSL8048, and MSL8096 OCP
119