3.
Pull up on the extraction handles and rotate them outward 90 degrees (
) until they
click open.
4.
Lift the memory carrier assembly out of the chassis (
NOTE:
To avoid damage to the handles, Hewlett Packard Enterprise recommends rotating
the handles inward and snapping them into place when servicing the system DIMMs or any
time the carrier is out of the chassis. Before replacing the memory carrier, press the button
to release the extraction handles. Use the handles to replace the memory carrier into the
chassis.
Figure 24 Removing and Replacing the Memory Carrier Assembly
Replacing the Memory Carrier Assembly
CAUTION:
Ensure the processor board assembly is fully seated before you replace the memory
carrier assembly. The processor board assembly access door must be flush with the front bezel.
To replace the memory carrier assembly, follow these steps:
1.
Ensure that the extraction handles are positioned in the outward, unlocked position.
2.
Align the memory carrier assembly with the front and rear chassis guide slots.
NOTE:
Assembly side 0 is on the left, and assembly side 1 is on the right as viewed from
the front of the chassis.
56
Installing the System
