Direct Attached Max Targets
Number of disk drives that spin up at the same time (default
1 drive).
Expander Spinup Delay
Expanders are not supported.
Expander Max Target Devices
Expanders are not supported.
PHY Properties Screen
The PHY Properties screen enables you to view and modify PHY specific settings. To access
PHY Properties, press
Enter
on the PHY Properties field from the Advanced Adaptor Properties
screen.
You can perform the following actions from PHY Properties:.
•
To display the next PHY, press
N
.
•
To display the previous PHY, press
P
.
•
To reset the Link Error Counts for this PHY or all PHYs, press
Enter
on Reset Link Error
Counts. Resetting Link Error Counts issues a PHY Link Error Reset. The following prompt
displays when you press
Enter
:
Are you sure you want to reset Phy error counts?
Reset error counts for this Phy only
Reset error counts for all Phys
Cancel
NOTE:
The Link Error Settings values on this screen display the current values for this PHY
only, and are not modifiable. To modify the Threshold values, you must return to Advanced
Adapter Properties screen.
PHY
Displays the PHY number current information.
SAS Port
Indicates the associated SAS Port (0 to N) as configured on this
adapter.
Link Status
Indicates the PHY link status. Possible values are:
•
Enabled, Unknown Link Rate
•
PHY Disabled
•
Enabled, negotiation failed
•
Enabled, SATA OOB Complete
•
Enabled, 1.5 Gbs
•
Enabled, 3.0 Gbs
Discovery Status
32 bit hexidecimal value indicating the discovery status for the PHY
or Expander. Currently defined values are:
•
Discovery completed successfully - 0x00000000
•
Loop Detected - 0x00000001
•
Unaddressable device exists - 0x00000002
•
Multiple Ports - 0x00000004
•
Expander Error - 0x00000008
•
SMP Timeout - 0x00000010
•
Out of route entries - 0x00000020
•
SMP Response Index Does Not Exist - 0x00000040
•
SMP Response Function Failed - 0x00000080
•
SMP CRC error - 0x00000100
HPE 8 Internal Port SAS HBA (SAS Controller)
297
