HP 3000/9x9KS Series, Service Manual, Page: 43 / 352

Install and Configuration 2-23
3. Check to see if the remote console is locked, if so, unlock it with the Unlock Remote (
UR
) command,
before configuring access or enabling remote console.
4. When dialing in for remote console access, there is no speed sensing, so it is necessary to verify that
the remote console port is configured for the same speed as the originating modem. To configure the
remote console port for the appropriate speed, use the Configure Access (
CA
) command mode. The
following information is displayed:
5. If the port configuration needs to be changed, type
Y
and enter the appropriate information.
6. To enable the remote console enter the Enable Remote (
ER
) command at the
CM>
prompt.
7. To disable the remote console enter the Disable Remote (
DR
) command at the
CM>
prompt.
8. When finished, exit the PDC command mode and put the key switch back into the ON position.
CM> CA
Current remote support modem port configuration:
Modem: Internal modem
Internal modem autoanswer: On
Bit Rate:
2400 (bits/sec)
Protocol:
Bell
System identification:
Do you wish to change the configuration? (Y/N):