Honeywell UDC 2300, Product Manual

Page: 20 / 185

Installation
10 UDC2300 Controller Product Manual 12/00
Mounting Method
Before mounting the controller, refer to the nameplate on the outside of the case and
make a note of the model number. It will help later when selecting the proper wiring
configuration.
Panel
20752
Figure 2-4 Mounting Method
Mounting Procedure
Table 2-5 Mounting Procedure
Step Action
1
Mark and cut out the controller hole in the panel according to the dimension information
in Figure 2-3.
2 Remove the screw cover and loosen the screw on the front of the controller. Pull the
chassis out of the case.
3 Orient the case properly and slide it through the panel hole from the front.
4 Remove the mounting kit from the shipping container and install the kit as follows:
•
Install the screws into the threaded holes of the clips.
•
Insert the prongs of the clips into the two holes in the top and bottom of the case.
•
Tighten both screws to secure the case against the panel.
•
Carefully slide the chassis assembly into the case, press to close, and tighten the
screw. Replace the screw cover.